Philips Lumea BRI944 Manuel page 17

D Clean & store after treatment
A
6 Move to an adjacent spot and press the flash button again. The surface of
the attachment that is in contact with your skin is slightly larger than the
light exit window. The surface of the attachment should overlap the
previous spot to make sure you flash the complete skin area. DO NOT flash
the same spot more than 3 times.
7 Continue until you have treated the full area. There are two treatment
modes (see 'Two treatment modes: Stamp & Flash and Slide & Flash').
8 Turn off the device when you finished the treatment.
9 Remove hair before every next treatment, as long as hair is still visible.
Note: Do not try the device on difficult or sensitive areas (ankle and bony area).
1 Unplug the device from the power outlet.
2 Let the device cool down.
3 Moisten the soft cloth supplied with a few drops of water.
4 Take the attachment off the device.
5 Clean the light exit window of the device (A).
17
English