Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C.3 Wall Mounting
Install heater with the supplied hardware in accordance with
the figures and instructions below.
Step 1: Secure wall and stabilizing brackets to mounting
surface (Figure 3).
Figure 3 – Install mounting bracket
Step 2: Position heater face down on floor with terminal box
towards mounting brackets. (Ensure that baffles
are installed [see Section C.2, page 4]). Angle
heater such that the terminal box rests on bottom
of wall bracket. Lift top of heater and align with top
stabilizing brackets.
Secure top with supplied 1/4"-20 hex bolts and lock
washers (Figure 4).
Figure 4 – Wall mounting diagram
Step 3: Secure bottom of heater to wall mounting brackets
with supplied 1/4"-20 hex bolts and lock washers
(Figure 5).
Figure 5 – Attach heater to mounting brackets
WARNING. Improper orientation of the heater
could affect the safe and reliable operation of the
heater.
WARNING
6
C.4 Floor Mounting
Step 1: Position heater face down on the floor with terminal
box towards the wall (Figure 6).
Figure 6 – Floor mounting diagram
Step 2: Fasten top stabilizing bracket(s) and floor mounting
bracket(s) to the unit. Floor mounting brackets may
be mounted in one of three orientations (Figure 7).
Figure 7 – Install mounting bracket to heater
Step 3: Lift top of unit and position heater vertically against
the wall. Secure stabilizing and floor mounting
brackets to the mounting surfaces (Figure 8).
Figure 8 – Attach heater to floor and wall
WARNING. Never install one heater above the
other.
WARNING
To ensure safe operation, heater must be installed,
as shown in
Figure 5 and
fins in the incorrect orientation may result in an
unsafe condition (refer to Table 1, page 4).
Figure 8. Installation with
Publicité
Chapitres
Table des Matières
