Front View; Rear View; Rackmounting - Tripp-Lite B021-000-19-HD2 Manuel Du Propriétaire

Introduction

Front View

1
Handle: Pull to slide the module out; push to slide the
module in.
2
LCD Monitor: After sliding the module out, flip up the cover to
access the LCD monitor, keyboard and touchpad.
3
Keyboard
4
Rackmounting Brackets: The brackets secure the chassis to
an EIA-standard 19-inch rack or rack enclosure.
5
2-Button Touchpad: Press the left button to left-click; press
the right button to right-click. Scroll up and down the screen by
running finger up or down the far right side of the touchpad.
6
Console and LCD Controls: The controls located here include
the console power On/Off button and the buttons used to control
the position and picture setting of the LCD display.
7
Pass-Through USB Port: This port is inactive until a USB A
male/male cable (Tripp Lite UR020-Series) is used to connect
the pass-through port on the back of the console to a USB port
on a computer or KVM switch. When active, a USB device
connected to the front of the console will be available for use
with the connected computer or KVM switch.

Rear View

1
Console Port Section: Connects the console to your server or
KVM switch with the included KVM cable kit.
2
Power Socket: The AC power cord plugs in here.
3
Pass-Through USB Port: This port is connected to the pass-
through USB port on the front of the console. The front pass-
through port is active when a USB A male/male cable (Tripp Lite
UR020-Series) is connected between the pass-through port on
the back and a USB port on a KVM switch or server.

Rackmounting

Tripp Lite's 1U Rackmount Console is designed for mounting in a 1U
rack system. The various mounting options are explained in the
sections that follow.
Standard 4-Post Rackmounting
The standard rackmounting brackets that come attached to the unit
allow it to be installed in EIA-standard 1U racks by a single
individual.
1
Slide out the rear mounting brackets from the console, and
mount both brackets (separate from the console) to the inside
rear of a 1U rack system using user-supplied screws.
2
Gently slide the console into the two rear-mounted brackets in
the rack. Secure the console in place by inserting user-supplied
screws.
2-Post Rackmounting
The console can also be mounted in a 2-post rack using the
optional 2-Post Rackmount Kit (Tripp Lite model B019-000). The
mounting hardware allows for the console to be opened with the
drawer in any position. The kit provides added stability and prevents
the console frame from twisting. See the B019-000 Owner's Manual
for detailed mounting instructions.
2
6
3
7 5
2
1
2
2
1
4
3 1