Important - Quantum QM-TWO Manuel Du Propriétaire

FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) High Pass / Low Pass filter controller
(2) Selector HPF (High Pass) – OFF – LPF (Low Pass)
(3) Input level controller
(4) Audio signal inputs (L & R)
(5) High level inputs for speaker wires, coming from the head unit
(6) Selector INPUT (high - low)
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) REM terminal for the turn on connection
(2) +12 V terminal for the positive-connection of the battery
(3) GND terminal for the ground
(4) Vehicle's battery
(5) In-Line Fuse (external, included in delivery)
(6) Turn on wire from the head unit or the electrical antenna
2-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive 2 loudspeakers, in
stereo connect the following setup:
(1) To the head unit, line output left
(2) To the head unit, line output right
(3) Loudspeaker left
(4) Loudspeaker right
1-CHANNEL OPERATION MONO (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) To the head unit, line output left or subwoofer output
(2) To the head unit, line output right or subwoofer output
(3) Subwoofer

IMPORTANT!

Always observe the correct polarity of all connections!
11