Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.2 Display (H20D+ series)
"Temp" and "ºC"
Real
value
Temperature
Remote
External
Hotplate
control
probe
Figure 6
Characters
Displays the temperature when the heating
function is ON.
Displays the stirring speed when the stirring
"Stir"
function is ON.
Displays a "Hot" warning if the heating
"Hot"
plate's temperature is above 50°C after
switching OFF the heating function.
Displayed
"Probe"
temperature sensor.
"Remote"
Displayed when using the remote control.
"Err"
Displayed in case of an error.
Set value/
Displays the real and set temperature or
Real value
stirring speed value when the function is ON.
Rapid heating mode, under which the heating
A
speed is the fastest but there may be some
overshoot
Standard heating mode, under which the
B
heating speed is faster and the overshoot is
smaller
Steady heating mode, under which the
C
heating speed is slower but the overshoot is
small or no overshoot
Note：
If both the heating and stirring functions are
started at the same time, the heating function
is always the priority. In that case, if the
speed is changed by turning the stirring
knob, the display will show the stirring speed
for 5 seconds and then goes back to the
temperature.
Heating mode setup: Startup and during the
initialization, rotate the heat knob, select
among the mode A/B/C. The mode will be
automatically locked after 3 seconds. If you
need to adjust again, please repeat the
same setting operation after restarting the
machine.
Stir
Heating
warning
mode
Descriptions
when
using
the
Table 3
7
Error
Set value
external
Publicité
Table des Matières
