Marshalltown Speed Striker STRIKE45-L Mode D'emploi page 7

Step 5 – Thread the exposed metal end of the throttle
cable into the throttle lever. The lever will need to be
"opened" to expose the hole it fits into. Back out the set
screw to allow the cable to pass through.
Step 7 – Secure throttle cable using clips, as shown
above.
WS#1716
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
INSTALLING THROTTLE CABLE
Step 6 - Once cable is through throttle lever, return the
lever to the "idle" position shown above. Using pliers, pull
all extra slack out of the cable, making sure you are not
actually opening the throttle at the carburetor. Once all
slack is removed, tighten locking screw.
Note – the plastic housing of the throttle cable will fit up
into the throttle cable housing.
7 of 16