Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Battery back up
The clock time and alarm (if set) can be maintained during a power failure by 2 x AAA/ LR03
batteries (not supplied).
Once the power is restored, check the time to make sure it is accurate and re-set if necessary.
Inserting the Batteries
1.
Open the battery compartment at the bottom of the unit by pressing on the catch and
removing the cover.
2.
Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment,
following the polarity as shown on the diagram inside the compartment.
3.
Replace the battery compartment cover.
Setting the clock and alarm
Setting the clock
1.
Press and hold the TIME (12) button and the hour/minute digits will flash.
2.
Use the HOUR (10) button to set the hours.
3.
Use the MINUTE (11) button to set the minutes.
4.
Press the TIME (12) button again to confirm the clock time setting and the hour / minute
digits will become solid.
Setting the alarm
Before setting the alarm time, make sure the clock has been set.
1. The unit remains in the standby mode.
2. Press and hold ALARM 1 (7) / ALARM 2 (6) button for 2 seconds and the hour / minute digits
will flash.
3. Press the HOUR (10) button to set the hours.
4. Press the MIN (11) button to set the minutes.
5. The unit will then return to the clock time display after 5 seconds.
Using the alarm function
This unit allows you to wake up by buzzer or radio.
1.
The unit remains in the standby mode.
2.
To adjust the alarm time, follow the steps in "Setting the clock and alarm".
3.
To select the buzzer or radio mode for ALARM 1, press the ALARM 1 (7) button repeatedly.
The corresponding AL1 buzzer Indicator (2) or AL1 radio Indicator (2) will light up on the
LED display.
4.
To select the buzzer or radio mode for ALARM 2, press the ALARM 2 (6) button
repeatedly. The corresponding AL2 buzzer Indicator (5) or AL2 radio Indicator (6) will
light up on the LED display.
5.
When the preset alarm time is reached, the alarm will sound in the selected alarm buzzer
mode or radio will sound in the selected alarm radio mode.
6.
To stop the alarm, press the
same time the next day.
7.
To disable the alarm function, press the ALARM 1 (7) or ALARM 2 (7) button repeatedly
until the selected buzzer indicator or radio indicator disappears.
EN
ON/OFF (8) button. The alarm will sound again at the
2
Publicité
Table des Matières
