Panamax PF POWER BATT1500-EXT Mode D'emploi page 2

Installation Guide
The UPS is supplied with rack mounting rails, mounting ears, and all the hardware.
Follow the below steps to complete the rack installation.
INSTALLING BATT1500-EXT INTO RACK
1. BATT1500-UPS must be installed directly underneath the UPS
2. Attach the mounting ears to each side of BATT1500-EXT
3. Attach the adjustable length rack mounting rails to the rack.
4. Slide the BATT1500-EXT into the rack on the rails
5. Use screws to secure the mounting ears to the rack
TURN UPS AND BATT1500-EXT OFF
6. CAUTION! - Turn off the UPS that BATT1500-UPS will be connected to
7. CAUTION! - Switch the circuit breaker on BATT1500-UPS to the OFF position.
CONNECT THE BATT1500-EXT TO THE UPS
8. Connect the battery pack's output cable assembly into the UPS's input port
9. Ensure that the colors of the battery pack cable and UPS input port are
matched: red-red, black-black, green-green.
TURN UPS AND BATT1500-EXT ON
10. Switch the circuit breaker on BATT1500-EXT to the ON position
11. Turn on the UPS on.
12. In the UPS setup menu, configure the UPS to use an external battery pack. Refer to the UPS manual for details.
UPS
NON
BANK 4 CRITICAL BANK 3
LOAD
1
BATT1500-EXT
PUSH TO RESET, 15A
CRITICAL LOAD
NON
9
CRITICAL
BANK 1
CRITICAL BANK 2
LOAD
LOAD
PUSH TO RESET, 15A
NON-CRITICAL LOAD
OUTPUT:
48V
5
8
CRITICAL
LOAD
2
2
3
4
15A PUSH
TO RESET
COMMUNICATION CARD
IR1
IR OUT IR STATUS
MAIN POWER
125 / 12A
IR2
USB
10
ON
7
OFF