shower to become unstable and fall over hurting you, children or property.
d) THIS IS NOT a recreational device. DO NOT climb on, hang from solar shower or stand on base.
e) Use only as intended.
f) When not in use, store the solar shower in an area away from the play of children.
3.4- Safety warnings regarding the use
a). The use of this product by children alone is forbidden. Children should always be supervised.
b) Warning: The use of any accessory or attachment, other than those recommended in this
instruction manual, may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
c) Remarks: The safety precautions and instructions given in this manual are unable to cover in detail
all the conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
IV- GETTING STARTED
Before any intervention on product, ensure that product is disconnected from its
power source.
4.1- Unpacking
Remove product from its packaging.
Check that tool and accessories are not damage
4.2- Assembling the shower
1. Select one threaded end of the extension pipe (b) and wrap 2 to 3
times with "Teflon" tape (not provided).
Then thread shower head (a) onto taped end of pipe (b).
DO NOT OVERTIGHTEN (see FIG.2)
2. Tightly wrap remaining threaded end of extension pipe (b) with
"Teflon" tape 16 to 20 times. Carefully begin threading wrapped
end of extension pipe (b) into fitting on upper shower tube (c).
Gently complete threading pipe into shower using final turn so
shower head is pointing in a downward direction.
NOTE: If extension pipe is stopped by end of threads in any other
orientation, rotate pipe in a counter-clockwise direction until it is
pointed downward.
The extension pipe must point in a downward direction for proper
operation (see FIG.2)
NOTE: In case of leaks at the attachment points from step 1 or 2,
remove extension pipe from fitting, wrap threading 3 to 4 times
with "Teflon" tape and reattach (see FIG.2)
3. Place and align shower upper tube (2) on lower tube (5).
NOTE: Handle and shower head need to face the same direction.
Press the upper tube down into lower tube. (see FIG.3)
4. Turn locking ring (3) clockwise to securely connect upper tube
(2) to lower tube (5) (see FIG.3)
5. Attach garden hose to inlet port (7) of shower and water supply.
NOTE: Be sure hose is placed safely to avoid any tripping hazards.
Fig.2
Fig.3