DS Produkte 03266 Mode D'emploi page 4

EN
Unpacking
1. Unpack the items supplied and remove all protective fi lms that
may be present.
2. Check all parts for possible transport damage. If you fi nd any
damage, do not use the article (!), but rather contact the cus-
tomer service department immediately.
Assembly
1. Plug the square end of the joint into the mount on the bottom
of the spotlight.
2. For securing in the ground: Plug
3. Insert/change the motif template:
Putting Into Operation
CAUTION: Laser Radiation! Do not look directly into the
beam or look at it directly using optical instruments. Laser
radiation can result in blinding and permanent damage to
the eyes.
1. Set up the laser spotlight no more than 10 metres away from
the object which is to be illuminated. Do not place it near to
other light sources so that the light sensor can respond to
darkness! Plug the ground spike into the ground.
2. Align the laser spotlight. Make sure that it does not shine into
people's fi eld of vision (public paths, roads, windows etc.)!
3. Always lay the mains cable in such a way that it does not pre-
sent a trip hazard.
4. Connect it to a properly installed plug socket.
5. Switch on the laser spotlight:
When darkness sets in, the spotlight
automatically switches on and projects
motifs. It switches off when it gets light
again.
6. Switch the laser spotlight off entirely: fl ip the On/Off switch to
the middle position.
In sub-zero temperatures it may take a few minutes for the
spotlight to light up fully.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
Article Number 03266
the round end of the joint onto the
ground spike.
For indoors: Plug the round end of
the joint into the base.
– unscrew the glass cover,
– tilt the spotlight so that any motif
templates that may be used
drop out,
– insert the motif templates you
want with the thinner end fi rst
into the openings of the red and
green laser light source,
– screw on the glass cover.
– fl ip the On/Off switch to position
I: green light
– fl ip the On/Off switch to position
II: green and red light
Customer Service / Importer:
Technical Data
Article number:
Spotlight
Model number:
Voltage:
Type of protection:
Power P(± 10 %):
Wavelengths:
Irradiance:
Laser class:
Mains adapter
Model number:
Input voltage:
Output voltage:
Power:
Protection class:
Type of protection:
Disposal
The packaging material is recyclable. Dispose of the pack-
aging in an environmentally friendly manner.
Dispose of the article in an environmentally friendly manner.
It should not be disposed of in the normal household waste.
Please dispose of it at a recycling centre for used electrical
and electronic devices.
All rights reserved.
03266
TS-16990
5 V DC
IP44
223 μW (green) / 458 μW (red)
λ 532 nm (green) / λ 650 nm (red)
< 1 m W/m²
2 acc. to IEC 60825-1:2014
YC
100 – 240 V~ 50/60 Hz
5 V DC, 1 A (max.)
3 W (max.)
II
IP44
✆
+49 38851 314650 *)
Instructions
Z 03266 M DS 0816