Suntex SX505A-8 Instructions D'utilisation page 2

FAILURE TO OBSERVE THESE WARNINGS
This insTrucTion manual conTains
imporTanT safe­Ty informaTion.
re­ad
care­fully
informaTion
This Tool.
• Always operate, inspect and maintain this
tool in accordance with American National
Standards
Portable Air Tools (ANSI B186 .1) and any other
applicable safety codes and regulations .
• For safety, top performance and maximum
durability of parts, operate this tool at 90
psig/6 .2 bar max air pressure with 1/2"
diameter air supply hose .
• Always wear impact-resistant eye and face
protection when operating or performing
maintenance on this tool . Always wear
hearing protection when using this tool .
• High sound levels can cause permanent
hearing loss . Use hearing protection as
recommended by your employer or OSHA
regulation .
• Keep the tool in efficient operating condition .
• Operators and maintenance personnel must
be physically able to handle the bulk, weight
and power of this tool .
• Air under pressure can cause severe injury .
Never direct air at yourself or others .
Always turn off the air supply, drain hose
of air pressure and detach tool from air
supply before installing, removing or
adjusting any accessory on this tool, or before
performing any maintenance on this tool .
Failure to do so could result in injury . Whip
hoses can cause serious injury . Always check
for damaged, frayed or loose hoses and fittings,
and replace immediately . Do not use quick
detach couplings at tool . See instructions for
correct set-up .
• Air powered
use .
uncomfortable positions over extended
periods of time may be harmful to your
hands and arms . Discontinue use of tool if
SX505A-8: Parts Breakdown & Operating Manual
COULD RESULT IN INJURY
This insTrucTion
and unde­rsTand
Be­fore­ ope­raTing
Institute Safety
tools can vibrate
Vibration, repetitive motions or
manual
all
Code of
in
2
discomfort, tingling feeling or pain occurs .
Seek medical advice before resuming use .
• Place the tool on the work before
starting the tool .
• Slipping, tripping and/or falling while
operating air tools can be a major cause of
serious injury or death . Be aware of excess
hose left on the walking or work surface .
• Keep body working stance balanced and firm .
Do not overreach when operating the tool .
• Anticipate and be alert for sudden changes in
motion during start up and operation of any
power tool .
• Do not carry tool by the hose . Protect the
hose from sharp objects and heat .
• Tool shaft may continue to rotate briefly
after throttle is released . Avoid direct
contact with accessories during and after
use . Gloves will reduce the risk of cuts or
burns .
• Keep away from rotating end of tool . Do not
wear jewelry or loose clothing . Secure long
hair . Scalping can occur if hair is not kept
away from tool and accessories . Choking
can occur if neckwear is not kept away from
tool and accessories .
• Impact wrenches are not torque control
devices . Fasteners with specific torque
requirements must be checked with suitable
torque measuring devices after installation
with an impact wrench .
• Use only impact wrench sockets on this tool . Use
accessories recommended by Sunex Tools .
Do not use hand sockets and accessories .
• Do not lubricate tools with flammable or
volatile liquids such as kerosene, diesel or
jet fuel .
• Do not force tool beyond its rated capacity .
• Do not remove any labels . Replace any
damaged labels .
rev. 02/2/07