ELAC Uni-Fi 2.0 Mode D'emploi page 9

Center Speaker Setup
The ELAC UC52 center channel is designed to produce dialog sounds and should be positioned above or below
(fig. 3) your television. Align it with the center of the television. As much as possible, try to keep the UC52 close
to the same level (height) as your front speakers for a more even sound stage. Keeping the same height for the
center channel can be very challenging so it might be necessary to tilt the center speaker up (if too low) or down
(if too high), to aim it towards the listening area.
PLACE ABOVE
TELEVISION
OR BELOW
3
FIG. 3
Optimal results for the center are obtained by setting the receiver/processor center channel size to small. If you
have a choice, set the crossover frequency between 50 to 100Hz.
ELAC Uni-Fi 2.0 Speakers | www.elac.com | Page 8