Publicité
Les langues disponibles
Les langues disponibles
01A/02A Series Models
1.
The range hood must be installed just above the cooktop.
The minimum distance from the cooking surface to the bottom of the range hood must be 24".
2.
3.
The total weight of the 01A/02A range hood unit is 18 lbs. (8 kg)
4.
Power requirements are:
01A: AC120 V, 60 Hz, 1.5 Amp
02A: AC120 V, 60 Hz, 2.1 Amp
CAUTION:
Check that the hood is correctly installed, since incorrect installation could result in the detachment of
the range and that unit could fall.
To protect hands from injury, wear working gloved when installing the range hood.
Installation Instructions, Revised 05/13/13
RANGE HOOD LOCATION
INSTALLATION INSTRUCTIONS &
USE & CARE GUIDE
01A/02A Series Models
Publicité
Table des Matières
Sommaire des Matières pour Air-Pro 01A Serie
- Page 1 INSTALLATION INSTRUCTIONS & USE & CARE GUIDE 01A/02A Series Models 01A/02A Series Models RANGE HOOD LOCATION The range hood must be installed just above the cooktop. The minimum distance from the cooking surface to the bottom of the range hood must be 24”. The total weight of the 01A/02A range hood unit is 18 lbs.
- Page 2 Installation Instructions, Revised 05/13/13...
-
Page 3: Safety Instructions
SAFETY INSTRUCTIONS Before installation and operation, read these instructions Installation work and electrical wiring must carefully and use this product only in the manner described be done by a qualified person(s) in by the manufacturer in the operation manual. accordance with all applicable codes and The instructions shown below are used to alert you to standards, including fire-rated construction. -
Page 4: Preparation
PREPARATION WARNING: If the range hood is not installed properly, it could become detached and fall. Ensure that the metal duct does not touch other metal housing materials, otherwise fire or electric shock could result. 7” Round Duct (for Vertical Discharge) 1. - Page 5 Installation Instructions, Revised 05/13/13...
- Page 6 Installation Instructions, Revised 05/13/13...
- Page 7 USE AND CARE WARNING! Do NOT operate the blower/ventilator system without the filters in place, or with dirty, grease laden filters. OPERATING CONTROLS: Always activate the ventilator or when using appliances. For the best performance, turn on the blower a few minutes before starting to cook to establish an airflow pattern within the room.
- Page 8 CAUTION: The neutral wire (usually white) for the ventilator must connect to the same neutral wire that comes from the electrical panel to the liner. Factory Installed Variable-Speed Wiring Details Black 120 volt AC from electrical panel (usually black) White Neutral from electrical panel (white) Green Ground from electrical panel (usually green)
- Page 9 Brand Ventilation Products What is Covered ™ VMI Inc. warrants its Air-Pro brand products to the original user, to be free of defects in materials and workmanship for three (3) years from the date of purchase. VMI Inc., at its option, will repair or replace the complete unit or any defective component without charge providing that, if requested, the product or defective component is promptly returned, prepaid to the address below.
- Page 10 Instructions d'Installation et Utilisation de Soins Guide 01A/02A Série Modèles 01A/02A Série Modèles GAMME EMPLACEMENT CAPOT La plage du capot doit être installé juste au-dessus de la cuisinière. La distance minimale de la surface de cuisson et le bas de la gamme du capot doit être de 24 ". Le poids total du 01A/02A de la hotte est de 18 lbs (8 kg) .
- Page 11 Installation Instructions, Revised 05/13/13...
-
Page 12: Consignes De Sécurité
CONSIGNES DE SÉCURITÉ Avant l'installation et le fonctionnement, lire attentivement les codes et les normes applicables, y ces instructions et utiliser ce produit uniquement de la compris au feu de la construction manière décrite par le fabricant dans le manuel d'utilisation. Suffisamment d'air est nécessaire pour Les instructions ci-dessous sont utilisés pour vous avertir une bonne combustion et épuisant des gaz... - Page 13 PRÉPARATION D'AVERTISSEMENT: Si la plage capot n'est pas installé correctement, il pourrait se détacher et tomber. S'assurer que le conduit métallique ne touche pas d'autres logements métalliques matériaux, sinon un incendie ou un choc électrique pourrait entraîner. 1. Selon les conditions où la plage du capot est 7”...
- Page 14 Installation Instructions, Revised 05/13/13...
- Page 15 Installation Instructions, Revised 05/13/13...
-
Page 16: Utilisation Et Entretien
UTILISATION ET ENTRETIEN D'AVERTISSEMENT! NE PAS faire fonctionner le ventilateur/le ventilateur système sans les filtres en place, ou avec sale, graisse laden filtres. CONTRÔLES DE FONCTIONNEMENT: Toujours activer le ventilateur ou lorsque vous utilisez les appareils. Pour des performances optimales, mettez le ventilateur quelques minutes avant de commencer à... - Page 17 AVERTIR: Le fil neutre (généralement blanc) pour le ventilateur doit se connecter sur le même fil neutre qui provient du panneau électrique de la chemise. Installé en usine à régime variable détails de câblage Noir 120 Volts AC de panneau électrique (généralement le noir) Blanc Position neutre du panneau électrique (blanc) Vert...
- Page 18 Brand Ventilation Products What is Covered ™ VMI Inc. warrants its Air-Pro brand products to the original user, to be free of defects in materials and workmanship for three (3) years from the date of purchase. VMI Inc., at its option, will repair or replace the complete unit or any defective component without charge providing that, if requested, the product or defective component is promptly returned, prepaid to the address below.