Publicité
Les langues disponibles
Les langues disponibles
IV. Fitting the bulb
To fit the supplied halogen bulbs you need to loosen the screw(E) securing the hinged front cover and swing
the cover down. The bulb is attached by spring-loaded holders at each end. Gently locate the bulb into
position, ensuring good contact at both ends. Tack care not to touch the glass of the bulb. If this does occur
clean the bulb with methylated spirit. Close the hinged front cover and re-tighten the top retaining screw(E).
DO NOT OVERTIGHTEN, THIS MAY DAMAGE THE GLASS.
V. Electrical Safety
This halogen lamp must be earthed. If it becomes necessary to re-wire the plug please follow these guidelines.
Always secure wires in plug terminals carefully. Make sure the cable is firmly lacated in the cord grip. NEVER
connect the green & yellow wire to any terminal other than one marked with the earth symbol 'E'or '
Regularly inspect all electrical connetions and wiring for damage. Any faults should be immediately rectified
before further use of this halogen lamp. Always have the wiring and connections checked by a qualified
electrician. In use, ensure all wiring and extension cables are kept clear of any cutting tools, sharp objects and
any other potential hazard such as wet floors, chemicals, solvents etc.
Note: if your main wiring differs in any way from Diagram A., consult a qualified electrician. Always ensure that
the mains supply voltage is correct. Always replace the fuse with one of an identical rating.
The lighting direction can not be adjusted to downward. Use a tripod when fully open, hang on until the
maximum angle.
VI. Change the bulb
1.Before maintenance and replacement of bulb always make sure the power supply has been switched off.
2. Open the lamp cover.
3.Twist the old bulb out carefully.
4.Twist a new bulb into the socket. Make sure that new bulb fits technical data of your lamp.
5. Close the lamp cover.
WARNING: The maintaining should be done only by a qualified electrician.
A : Centre Screw Knob
B : Twist Locks
C : Leg Hinges
D : Cable storage
E : Floodlight Housing Retaining Screw
F : Screw
Spare halogen lamp – Ref. 96201
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for environmental safe recycling.
' .
Publicité
