Safety Guidelines; Parts; Operating Instructions - B+BTec Diamond3 professional UDK68 Manuel D'utilisation

DIAMOND 3
Use the supplied water tank or a direct
connection to the water supply.
• Pay attention to the power
supply.
On construction sites electrical appli-
ances should be connected to spe-
cially designed power supplies. Suita-
ble are grounded main power supplies
equipped with an earth leak switch of
max. 30 mA or separating transform-
ers. Non-grounded common household
or similar power outlets are not suited
as a power source. For wet cutting or
drilling machines stricter safety stand-
ards are applicable. For extra safety
the machine must be connected by
one of the following methods:
– Main power supply equipped with
earth leak switch 30 mA; or
– Separating transformer, only one
machine may be connected at any
given time; or
– With an intermediate cable
equipped with a PRCD (GFCI) safety
switch of max. 30mA.
• Avoid contact with hands and
fingers with the rotating dia­
mond bit.
Doing so could cause serious injury.
• Do not leave the machine
turned "ON" when not in use.
Doing so could cause serious injury to
others.

SAFETY GUIDELINES

Warning and Caution symbols in this manual
are for a safer use. Read them attentively
and understand their meaning.
DANGER: Indicates an poten-
tially hazardous situation which,
if not avoided, will result in death
or serious injury.
UDK68
®
WARNING: Indicates an poten-
tially hazardous situation which,
if not avoided, could result in
death or serious injury.
CAUTION: Indicates an poten-
tially hazardous situation which,
if not avoided, may result in
minor or moderate injury.
ATTENTION: Indicates a practice
not related to personal injury
which, if not avoided, may result
in property damage.

PARTS

• Water injection head
For connection to Diamond3
Ø 4 - Ø 68 mm
• Water tank 5l.
• Drill guide
• Socket head screwdriver 3 mm

OPERATING INSTRUCTIONS

• Use the water injection head in com-
bination with the supplied water tank
or direct connection to the main water
supply.
• The use of the drill guide is
recommended.
Mounting/changing the drill bit
• Clean and grease the machine bit
adapter.
• Mount the bit with the flat side oppos-
11
GB
® tile drills