Operation - The Charger; Maintenance - Enduro LI1220 Manuel D'utilisateur

Please pay attention to the polarity and do not short-circuit the positive
(+) and negative (-) terminals of the battery!
The LI1220 battery may not be connected in series or parallel with any
other battery to get a higher voltage or bigger capacity!
Before using the LI1220 Lithium-ion battery for the first time, it should
be fully charged!
OPERATION – THE CHARGER
ONLY use the supplied EN
2024C) to charge the battery. The battery may not be charged by the
output terminals!
With CPU control and pulse width modulation (PWM) technology, the charging current
and output voltage is controlled accurately to ensure a fully-charged battery and avoid
over-charging.
Do not charge the battery at a temperature below 0 degrees Celsius.
The charger will get hot during charging. Make sure that the charger is
used in place with good ventilation and free of dust. Have at least 10cm
space around the charger.
This charger is not designed as power supply.
The charger should not be opened. Any attempt at modification or repair by the user will
entail the loss of your guarantee.
The mains supply cord of this appliance can not be replaced; if the cord is damaged, the
appliance should be discarded.
Charging the battery:
After every use (and before storage) charge the battery immediately.
 Check the XLR plug of the charger for damages or loose wires.
 Open (slide aside) the cover of the 12V DC input jack of
the battery (marked with "Charge").
 Connect the XLR plug of the charger to the 12V DC input
jack of the battery and than connect the charger to the
AC power (100-240V, 50/60Hz).
 The LED on the charger will light in red, and the
charging process will start. When the battery is fully
charged, the LED will turn green.

MAINTENANCE

In general the LI1220 battery is maintenance-free.
The LI1220 battery can be cleaned with a damp cloth. Do not use any aggressive
cleaning chemicals.
Routinely check the battery's charge status.
Consider replacing the battery with a new one if you note either of the following
conditions:
®
battery charger (model: LI1220/TS-
DURO
®
EN LI1220 16
DURO
Ref: LI1220-UM-TKI-0115-Rev.A