Symbols Used In This Manual; Drill Safety Warnings; Electrical Connection - AGP DME52D Mode D'emploi

Symbols used in this manual

V...............volts
A...............amperes
Hz.............hertz
W..............watt
~.............alternating current
n
............rated speed
min ..........revolutions or reciprocation
-1
per minute
.........warning of general danger
......class II tool

DRILL SAFETY WARNINGS

1. Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
2. Use auxiliary handle. Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
4. Check the ground (earth) connection of the electrical plug.
5. Block off the working area and place warning signs on both sides of the wall when drilling through
from one side to the other.
INTRODUCTION
The machine is equipped with a tubular spirit level to aid in aligning when drilling horizontally. By positioning
the machine so that the bubble is in the center of the window one can drill a straight hole.
This machine is for the intended purpose of diamond core drilling of concrete, masonry, stone and similar
materials. It may also be mounted on a rig (drilling stand).
All other uses which are not for the intended purpose are prohibited.
It is equipped with a two speed gearbox.
All models are equipped with a mechanical safety clutch.
All models have electronics for soft start, overload protection, thermal protection.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
GB
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
do not dispose of electric tools,
accessories and packaging together
with household waste material
5