Package Contents - Dynex DX-M110 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DX-M110-Combo.fm Page 2 Tuesday, July 5, 2005 5:12 PM
2
DX-M110 PCI Modem
Contents
Français ....................................................... 3
Español ........................................................ 4

Package contents

• 56K data/fax/voice modem PCI card
• Driver & Application software CD
• RJ11 modem cable
• This guide
Features
Supports the ITU-T (CCITT) communication standards.
Data
V.92(Lite)
V.90, V.34, V.32bis, V.32
V.22bis, V.21
V.22Bell 103 & 212A
V.44,V.42bis & MNP 5 (data compress)
V.42 & MNP2-4 (error correction)
Fax
V.17 (14,400 bps)
V.29 (9,600 bps)
V.27 (4,800 bps)
Voice
Voice/Audio mode
Speaker/Headphone jack
Jacks
Telephone jack—plug your telephone into this jack.
Line jack—connect this jack to your wall jack using the RJ11 cable.
Mic jack—plug a microphone into this jack.
Spk jack—plug a speaker or headphone into this jack.
Installing the modem
To install the PCI modem card:
1 Disconnect the power to your computer.
2 Open your computer's case.
3 Press the modem card firmly into an empty PCI slot, then secure it
to your computer.
4 Close your computer's case.
5 Turn on your computer. Windows automatically detects the new
modem and the Device Driver Wizard opens.
6 Click Cancel to close this wizard.
7 Insert the Driver & Application CD into your CD or DVD drive.
8 Click Install Driver. The driver is installed automatically.
Note: Windows may notify you that the driver has not passed
Windows Logo testing. This is normal. If this happens, click OK or
Continue.
9 If a dialog box appears informing you to restart your computer,
restart it at this time.
10 Click Start, Accessories, Communications, then click New
Connection Wizard. The wizard helps you make a new dial-up
networking connection.
-OR-
Double-click the My Computer icon on your desktop,
double-click the Dial-up Networking icon, then click the Make
New Connection icon. The wizard helps you make a new dial-up
network connection.
Setting the modem dialing
location
To set the dialing location in Windows XP and Windows 2000:
1 Click Start, Settings, Control Panel, then click Phone And
Modem Options.
2 Click Edit on the Dialing Rules tab, then change your location.
To set the dialing location in Windows NT, Windows 98, and Windows ME:
1 Click Control Panel, then click Modem.
2 Click Dialing Properties on the General tab, then change your
location.
Legal notices
© 2005 Dynex. DYNEX and the DYNEX logo are trademarks of Best Buy
Enterprise Services, Inc. Other brands and product names are trademarks
or registered trademarks of their respective holders. Specifications and
features are subject to change without notice or obligation.
DX-M110 PCI Modem

Publicité

Table des Matières
loading

Table des Matières