Quick Configuration; Auto-Learning End-Stop; Loading Of Default Parameters - V2 BY Serie Manuel D'instruction

QUICK CONFIGURATION

We recommend following these instructions, in order to
check quickly the correct operation of control unit, motor
and accessories, and then changing the configuration in
case of any non-satisfactory parameter.
1.
2. StoP, Foto, CoS,
3. dir
4.
5.
LOADING OF DEFAULT
PARAMETERS
WARNING: This procedure causes the loss of all the
customized parameters, therefore it has been put outside
the configuration menu, to reduce the possibility of
executing it by mistake.
1.
2.
3. dEF
4. no
5. Si
6.

AUTO-LEARNING END-STOP

the mechanical stops correctly.
(see paragraph Direction pag. 48)
1.
2.
3.
4.
5.
6.
6.1
6.2
6.3
7.
-dEF
7.1
ESC
7.2
7.3
control panel will exit from the Time out programming
(20 sec- 1 min) retaining the last memorized value.
43
ATTENTION: before proceeding, make sure to position
ATTENTION: before proceeding set the dir parameter
StoP, Foto, CoS,
St.rt StAn
-APP
SEnS
FinE
Si
ATTENTION: If this procedure is not followed, the
ESC
FC