FW TR Serie Mode D'emploi page 6

TR-Series
IX. Troubleshooting
• Problem: Scale will not turn on
Solution: Check the batteries
•
• Problem: Displayed weight fluctuates randomly
• Solution: Make sure your workspace is stable and
free of any air currents or vibration
Problem: Displayed weight is inaccurate
•
• Solution: Perform a calibration adjustment
X. Error Codes
1. OUTZ - Zero range has shifted. Perform calibration
adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.
2. UNST - Scale is unstable. Use in a more stable
position.
3. HHHHH - Maximum capacity exceeded. Remove the
extra weight to avoid damaging the load cell.
4. L - Batteries are low. Replace the batteries.
- English