Releasing And Inserting The Battery Pack; Charging The Battery Pack - Bosch PB10-CD Consignes De Fonctionnement/Sécurité

Releasing and Inserting
Battery Pack
To release or insert the battery pack from radio unit, open
the charger door by unlocking the latch. Before inserting
battery pack, remove protective cap from battery pack. To
insert battery, align battery and slide battery pack into tool
until it locks into position. Do not force.
DOOR
RELEASE
LATCH
Charging Battery Pack
CHARGER OPERATION:
Insert battery and close door.
!
Charge only Bosch batteries BAT025-
BAT045. Other batteries may burst
WARNING
causing injury and damage. Read additional safety
information on underside of radio.
Open charger door by releasing latch. Plug the unit's power
cord into your standard power outlet. Before inserting battery
pack, remove protective cap, then insert battery pack into
charger.
1. The LCD will display the battery "ICON" and "CHARGING"
on the front of the unit. This indicates he battery pack is
charging.
2. When "CHARGING" disappears, charging is complete
3. If when you begin the charging process of the battery
pack, the "THERMOMETER ICON" is displayed on the LCD,
this indicates the battery pack is too hot or too cold.
The battery pack will begin to charge once it reaches the
proper temperature. The thermometer will disappear when it
begins to charge.
4.The purpose of the charging icon on the LCD is to indicate
that the battery pack is fast-charging. The charging icons
will disappear in less time if the battery pack was not
completely discharged.
5. When the battery pack is fully charged, the battery pack
can be inserted into a tool, or used to power the radio
instead of the power cord.
!
To prevent fire or injury when batteries
are not in tool or charger, always place
WARNING
protective cap onto end of battery pack.
BATTERY
PACK
10
PROTECTIVE
CAP