Protool PDC 18-4 Compact Mode D'emploi Et Liste Des Pièces De Rechange page 12

GB
PDC 18-4 Compact
LED green – lit continu-
ously: charged > 60 %
LED green – flashing
slowly: charged 30 % – 60
%
LED green – flashing
quickly: charged 0 % – 30
%
LED yellow – lit continu-
ously: battery is empty
LED red – lit continu-
ously: battery temperature
is outside the permitted
range.
LED red – flashing: indi-
cates a general fault, e.g.
incomplete contact, short
circuit, battery pack faulty,
etc.
7 Settings
WARNING
Risk of injury
Always switch off the machine before ad-
justing settings!
7.1 Changing direction of rotation
[1-7]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise ro-
tation
7.2 Changing gear
You can change gear using the gear switch
[1-5].
7.3 Adjusting the torque[1-6]
Fastening
Select the correct torque setting:
Position 1 = low torque
Position 12 = high torque
An acoustic signal sounds when the preset
torque is reached and the machine then
switches off. You must release and press the
ON/OFF switch [1-8] again to start the ma-
chine.
Drilling
Mark is aligned with drill symbol
mum torque.
7.4
The machine was designed for impact
drilling into tiles, masonry and stone.
Set the selector switch [1-4] to the hammer
symbol. Set the adjusting wheel [1-6] to the
drill symbol.
7.5
Turn the clamping sleeve [5-1] anticlock-
wise to open the jaws. The arrow on the
clamping sleeve indicates the opening direc-
tion. The tool can now be inserted into the
drill chuck.
Risk of injury
Clamp the tool centrally in the drill chuck!
Turn the clamping sleeve [5-1] clockwise to
clamp the tool securely
8
8.1
Press = ON, release = OFF
The speed of the machine depends on
how far the on/off switch is pressed in.
8.2
Magnetic, for storing bits and bit holders.
8.3
The user can attach the machine to work
clothing for short periods using the belt clip
(right/left).
8.4
Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
– Preset torque reached.
– "Block protect" - starting torque too
peep
high.
– Machine overloaded
9
Note the following information:
– Keep the ventilation slits on the machine
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger
and battery pack clean.
= maxi-
12
Impact drilling
Changing tools
CAUTION
Working with the machine
On/Off switch [1-8]
Bit depot [1-1]
Belt clip [1-9]
Acoustic warning signals
Service and maintenance