Viro VEGA Guide De L'utilisateur page 5

NOTE
• Fully charge the Vega™ before first use. Follow the charging instructions on page 9.
• Ensure the deck button and neck button are both locked in position.
• Put on all recommended protective gear.
• Fully read this entire user guide before attempting to ride.
• Ask a competent adult to help you ride until you are comfortable.
BIKE
Turn the unit ON. Release the kickstand and place one foot
1
flat on the floor for stability. Place your other foot on the
lowered footrest.
O = OFF
I = ON
Push off of the ground and press the throttle down with
3
your thumb. Bring your foot onto the other footrest.
SCOOTER
Turn the unit ON. Release the kickstand. Place one foot flat
1
on the floor for stability. Place your other foot on the front
of the deck.
O = OFF
I = ON
Push off of the ground and press the throttle down with
3
your thumb. Bring your foot onto the back of the deck.
2 Hold both handlebars with your thumb on the throttle.
Turn the handlebar left to turn left and right to turn right.
4
Slightly lean into the direction you are turning. Pull the
brake toward you to slow or stop the bike.
2
Hold both handlebars with your thumb on the throttle.
Turn the handlebar left to turn left and right to turn right.
4
Slightly lean into the direction you are turning. Pull the
brake toward you to slow or stop the scooter.
8
NOTE
An adult must assemble the handlebars to the unit.
1 2
Place the handlebar on top of the T bar
Unlatch the handlebar clamp. Use the
wrench to twist off the nuts from the and align the openings. The throttle
handle bar and remove the bolts and should face inward and the brake
handlebar covering. should face outward.
ADJUSTABLE HANDLEBAR
1 2
Unlatch the handlebar clamp. Press in the spring-loaded button.
THREE CONFIGURATIONS TWO KICKSTANDS
Position 1 - Folded
Position 2 - Bike
Position 3 - Scooter
3
Replace the covering over the handlebar,
and insert the bolts through the openings.
Place the nuts over the bolts and tighten
with the wrench. Latch the handlebar clamp.
3 4
Pull up or press down on the Latch the handlebar clamp to secure.
handlebar until the spring-loaded
button locks in the desired position.
LIGHTS
Scooter
Kickstand
Bike
Kickstand
Lights up when the unit is on.
5