Technical Specification - Arcam solo Manuel

technical
specification
Pre-amplifier
Inputs
Maximum input level
Input impedance
Signal/noise ratio
Co-axial outputs
Maximum output level
Output impedance
Optical output (TOSLINK)
Sample rate
Amplifier
Continuous power output, per channel, 80kHz measurement bandwidth
Both channels, 4Ω, 1kHz
Distortion, both channels 4Ω, 80% power, 1kHz
CD play-back
DAC
Frequency response (±0.5dB)
DAB receiver (where fitted)
DAC
RF tuning range
Sensitivity (typical)
Input impedance
Audio data rate (maximum)
Number stored services (maximum)
Solo iss4.id2
2.5Vrms
47kΩ
105dB
2.5Vrms
500Ω
44.1kHz (with CD playback),
48kHz (with DAB receiver),
otherwise muted.
75Wrms, 0.013% THD+n
0.011% THD+n
Wolfson 24-bit multilevel Delta-Sigma DAC
20Hz–20kHz
AKM 96kHz 24-bit Delta-Sigma DAC
174–240MHz (Band III)
1452–1490MHz (L -band)
–98dBm (VHF measurement to EN50248)
50Ω
256kbits/s MPEG layer II, protection level 3
128
13
FM receiver
RF tuning range
Sensitivity (typical)
Signal/noise ratio (at 200mV)
Distortion (THD at 200mV)
AM receiver (where fitted)
RF tuning range
Signal/noise ratio (at 200mV)
Distortion (THD at 30% modulation)
General
Supply voltage*
Power consumption
Size (W x D x H)
Weight (net)
Weight (packed)
Supplied accessories
*This is a Class 1 device and must be earthed. In Japan, the supply voltage is 100V, 50–60Hz.
Radio interference
Solo is an audio device containing microprocessors and other digital electronics. It has been designed to
very high standards of electromagnetic compatibility.
If Solo causes interference to radio or television reception (which can be determined by switching Solo
off and on), the following measures should be taken:
Re-orient the receiving antenna or route the antenna cable of the effected receiver as far as
<
possible from Solo and its cabling.
Relocate the receiver with respect to Solo.
<
Connect the receiver and Solo to different mains outlets.
<
If the problem persists, please contact your Arcam dealer.
E13
26/4/05, 7:59 pm
87 .5–108MHz
2µV
58dB
0.5%
522–1611kHz
40dB
1.5%
100V, 115V or 230V AC,
depending on shipping region
Stand-by 3.2VA;
Operational 50VA (typical), 400VA (maximum)
W430mm x D350mm x H79mm
7 .75kg
10.5kg
Mains lead
Wire dipole aerial (Band III)
Remote control handset and two AAA batteries
Instruction manual and registration card