Front Wheels - Baby Trend JG95B Manuel D'instruction

ASSEMBLY
Remove stroller from box. The front wheel
and rear wheels be installed prior to
MUST
use.

FRONT WHEELS

To attach the front wheels, unfold stroller as
described in the section following:
1) • Unlock the release lever (Fig. 1a).
Unfold stroller frame by pulling backward
on the stroller handle. Lean the stroller
backwards so that it rests on the handle
and rear axle frame and the front wheel
forks are pointing upward (Fig. 1b).
2) • Slide the front wheel onto the front forks
(Fig. 2).
3) • Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 1a
Fig. 1b
Fig. 2
Slot Front Fork
Axel Nut Retainer Plate Axel and Hub
Fig. 3
4) • With the wheel in position, tighten the axel
nuts and tighten with standard crescent,
box, or open end wrench. You should
feel significant resistance and the wheel
should be held tightly in place (Fig. 4).
REAR WHEELS
5) • Rest the stroller upside down, on the
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
6) • Tires are shipped un-inflated. The tires
should be inflated on a regular basis to the
P.S.I. specified on each tire. Always use a
bicycle style hand air pump to inflate the
tires. *Not included.
PARENT TRAY
WARNING:
Do not place hot liquids or more
than 3 pounds in the parent tray. Serious burns or
unstable conditions could result.
7) • To attach the parent tray, align the fittings on
the ends of the parent tray with the fittings
on the outsides of the handle. Hook the
hole in the parent tray. Pull outward on the
opposite end while pushing down on the tray
until locked onto the stroller handle. Please
be careful not to pinch your fingers when
installing the parent tray (Fig. 7). To remove
the parent tray, pull outward on one end of
the tray while lifting upward.
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 4
Fig. 5
Fig. 7
6