Assembly - Baby Trend HC34A Manuel D'instruction

ASSEMBLY

• Slide the left and right sides' Height
3)
Bracket onto the Seat Base (Fig. 3a).
Lock the brackets in place (Fig. 3b).
• Slide the Footrest onto the Seat Base
4)
(Fig. 4). Lock Footrest into place.
• Insert the front tube of the right and left
5)
side Upper Frame Assemblies into the
Height Adjuster (Fig. 5). The front tube
is easily distinguished from the rear
tube by the array of holes located on the
backside of the front tube.
5
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Height Bracket
Height Bracket
Fig. 3a
Fig. 3b
Footrest
Fig. 4
Upper Frame Assembly
Release Handle
Height Bracket
Fig. 5
• Squeeze the Release Handles on both
6)
sides simultaneously and push the tube
through the Height Adjusters until it locks
in the highest position (Fig. 6).
• Insert the Legs into the ends of the front
7)
tube of both the right and left Upper
Frame Assemblies (Fig. 7).
Note: Legs are properly connected
when the lock buttons are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the lock
buttons are engaged before use.
• Insert another Leg into the ends of the
8)
rear tube of both the right and left Upper
Frame Assemblies (Fig. 8).
Note: Legs are properly connected
when the lock buttons are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the lock
buttons are engaged before use.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Release Handle
Fig. 6
Hole
Lock Buttons
Fig. 7
Hole
Lock Buttons
Fig. 8
6