Cleaning The Filter; Caring For The Dishwasher; Cleaning The Door; Protect Against Freezing - Brandy Best RED6D Notice D'emploi

Notes:
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system.Remove any food remnants and
clean the filters under running water.
!
NOTE:
The entire filter assembly should be cleaned once a week.

Cleaning The Filter

To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures
on the last page and reinsert the entire assembly in the dishwasher, positioning in its seat and pressing downward.
!
WARNING!

Caring for the Dishwasher

The control panel can be cleaned by using a lightly dampened cloth. After cleaning,make sure to dry it thoroughly.
For the exterior use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.

Cleaning The Door

WARNING!

Protect Against Freezing

please take frost protection measures on the dishwasher in winter. Each time after washing cycles,
please operate as follows:
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve (Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
!
NOTE:
If your dishwasher cannot work because of the ice, please contact authorised service person.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of dishwasher could be decreased.
To clean the edge around the door, you should use only a soft warm,
damp cloth. To avoid penetration of water into the door lock and
electrical components, do not use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towel should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
17