iolite WISPR 2 Manuel D'utilisation page 5

Operate in 10 Easy Steps
3
Remove the filling chamber from the
WISPR™. Then place the ground material
into the filling chamber. Do not over pack,
otherwise airflow will be impeded.
4
After filling the chamber with your chosen
material place the filling chamber back
into your WISPR™ vaporiser.
5
Press On/Off switch downwards until you
can hear gas flow. (Mid position)
8
Pack the chamber
Insert the filling chamber
Turn it on
Operate in 10 Easy Steps
6
Light it
Activate the WISPR™ by slowly pushing
the On/Off switch completely downward
until it clicks. The sound of the gas flow
changes to a mild 'whisper' confirming
your WISPR™ is heating up. This usually
happens on the first try; if not, depress the
switch again within 5 seconds.
An orange light will also become visible
beside the WISPR logo after a few
moments to confirm your WISPR™ is
heating up. The light will disappear once
the optimum controlled temperature
is reached. Note that during its normal
working cycle, the sound made by the
WISPR™ when "On" is cut in and out by the
thermostat.
7 Let it heat up
Allow at least 45 seconds for your WISPR™
to reach its controlled operational
temperature of 190°C before inhaling.
This doesn't necessarily mean pipe
tobacco/plant material will be ready after
45 seconds. you may have to wait a little
longer.
9