Classic Accessories PRT-52-087T Mode D'emploi Et D'entretien page 11

STEP 5
ADJUSTING SNOW THROWER CAB ANGLE (FIG. 1-3)
CAUTION: No part of the fabric cab skin should touch the engine or exhaust system of your snow thrower.
PARTS NEEDED
1
Adjust cab to proper angle so that the mounting
bar ends [D] are parallel to the ground.
3a
Pull front corners of the fabric shell over the front corners of the cab frame.
2
Be sure to tighten both the lower mounting posts [M], [N]
and the upper mounting posts [K], [L] after positioning. To
properly support the cab be sure to tighten the lower mounting
bolts evenly on each side of the mounting post plates.
3b
Inner view of of fabric shell with front corner secured.
11
TOOLS NEEDED
12
OR
Adjustable
Wrench
OR
1/2 in. Socket
Wrench
DELUXE ARCHED SNOW THROWER CAB