FONESTAR FO-471-TX Mode D'emploi page 4

EN
SPLITTER FUNCTION VIA SWITCH WITH MULTIPLE RECEIVERS FO-472-RX
- Connect the digital A/V source to the transmitter INPUT using HDMI cable.
- Connect the transmitter output to the switch input using Cat 5e/6 cable.
- Use Cat 5e/6 100 or 120 meter cable respectively to connect the switch and all the receivers FO-472-RX
required (up to a maximum of 253) according to the IEEE-568B standard.
Note: it is not necessary to make any configuration in the receivers FO-472-RX.
- Power the transmitter and the receivers with the mains adapters provided.
- Connect the receiver OUTPUTS to the TV monitors using HDMI cable.
- Switch on the digital A/V source and the TV monitors.
NOTA: The use of Gigabit Ethernet switches is recommended. Never mix Fast Ethernet switches (100 Mbps)
and Gigabit Ethernet switches (1,000 Mbps) in the same installation..
- 4 -