Initial Use; User Maintenance - Herschel SUMMIT 2600 Instructions D'installation Et D'utilisation

All Herschel remote controls have the same frequency, so it is possible to control several heaters with just
one remote.
Safety & Energy-saving protection:
• If a heater with remote control is left switched on continuously for a week (168 hours), the
heater will automatically switch itself off and must be restarted.
• Heaters with remote controllers are equipped with an overheat switch which will cut power to
the heater if it senses an overheat in the electronics. Please let the heater cool down for 15
minutes before attempting to restart.

INITIAL USE:

Before first use, ensure the emissive (front) surface is free of fingerprints and other contamination before
turning on heater for the first time. There may be an odour or vapour from the heater on initial use or if
heater has not been used for an extended period. This is normal.

USER MAINTENANCE:

The heater may be wiped-down with a clean damp cloth. Do not use abrasive detergents to clean the unit.
In marine environments, the unit may be gently sprayed clean with clean water with the POWER TURNED
OFF and completely cool. After cleaning, it is advisable to warm the heater for 10 – 20 minutes to dry the
unit and prevent staining.
WARRANTY:
Register your product here:
The Herschel SUMMIT is guaranteed against failure due to faulty materials or workmanship for two years
from date of purchase*. In the unlikely event of failure of the unit within this time, the unit must be
returned to the supplier for repair or replacement. The guarantee is invalid if the correct installation
instructions as given in this leaflet have not been adhered to. Refer to Herschel Infrared Ltd's warranty
policy for full details. *Excludes Remote Control Unit.
See https://www.herschel-infrared.co.uk
Note your serial number here for future
reference:
COMPLIANCE WITH ECODESIGN DIRECTIVE 2009/125/EC:
• If SUMMIT is to be used indoors in an enclosed space to reach and maintain a defined temperature
level, the Herschel SUMMIT 2600 (non remote) must be used and is compliant if used with the
appropriate Hershel iQ controller.
• The legislation does not apply to SUMMIT 2600 or 2600R intended for use outdoors or for heating
indoors in an unenclosed space where this prevents application of EcoDesign regulations. Note
however in accordance with Ecodesign standards, the SUMMIT 2600R model will switch itself off if
left operating continuously for 168 hours (1 week).
• Herschel is not responsible for any breach of the legislation where the SUMMIT 2600 or 2600R are
used for enclosed indoor heating without an appropriate controller.
https://www.herschel-infrared.co.uk/customer-service/warranty-registration/
ENGLISH