Installation And Commissioning; Parts List; Functions - SIHOO M76 Manuel Utilisateur

User Manual

Installation and commissioning

1、Installation and commissioning.
2、 Check whether the parts are complete and damaged.
Choose a spacious and clean site when assembling. Paper is laid flat on the
3、
ground to prevent parts from colliding with the ground during installation.
Use a soft flannel to remove the dirt on the furniture surface after installation. DO NOT wipe
4、
the furniture with a rag with gravel.
1.Please use on the flat floor and one chair can only bear one person's weight;
Pls read the
2.To avoid using the wrong screws, please fix all the screws before tightening
Safety
them;
Instructions
3.Please don't let the child sit on the chair alone if he is under 5 year-old;
below carefully
4.Please don't sit on the armrest, in case cause some danger;
5.Do not stand on the chair or use it as a ladder or footsteps;
6.Please don't put overweight on the chair, or used as trolley;
7.Don't use sharp or hooked objects to scrape the chair and do not get it close
to the fire;
8.To avoid any harm to your fingers, don't insert them into the mechanism
while sitting .

Functions

(The size will be according to regular practice)
Lumbar support
depth & height
adjustment
Rotate the handle to adjust
the heightPull out the handle
to adjust the backrest tiltPush
in handle to lock backrest tilt

Parts list

Castor:5pcs
Seat cushion:1pc
Backrest screw(M6*35):4+1pcs
Assemble Introduction
1 Pressing the caster into the
base.
Armrest can
be rotated
up and down
Backrest tilt tension
adjustment +Tighten
-Loosen
Fix the back plate to the
4
seat with
screws including the shim.
0
Notice: Before installation, pls classify the screw, measure the screw lengh for easy assemble
(The size will be according to regular measurements; One more as a backup)
Mechanism:1pc
Base:1pc
Gas lift:1pc Hex wrench:1pc
Mechanism screw(M6*20):4+1pcs
(The size will be according to regular measurements ）
2 Insert the gaslift to the base.
The front
5 Put the mechanism into
4pcs(M6*35)
the gaslift and pull down
the armrest.
1 2 3 4 5 6
Backrest:1pc
Notice: Before installa-
tion, pls classify the
screw, measure the
screw lengh for easy
assemble
The front
Fix the mechanism to the seat
3
with 4pcs (M6*20) screws
including the shim； Pay
attention to the front and
back direction.
7 8 9 10 cm