Preparing The Tool; Loading The Tool - Porter Cable PCC790 Manuel D'instructions

WARNING:
avoid accidental firing. NEVER carry tool with finger on trigger.
1. Wear proper eye, hearing and respiratory protection.
2. Remove battery pack from tool and engage trigger lock-off.
3. Lock the pusher in the back position and remove all nail strips from the magazine.
4. Check for smooth and proper operation of contact trip and pusher assemblies. Do
not use tool if either assembly is not functioning properly.
5. NEVER use a tool that has damaged parts.
To oPeRATe THe NAIleR
WARNING:
for each nail followed by a release of both the contact trip and trigger after each nail.
WARNING:
engaged whenever any adjustments are made or when tool is not in use.
1. Fully depress contact trip against the work surface.
2. Fully pull trigger and motor will start. (nail will drive into work surface).
3. Release trigger.
4. Lift contact trip off work surface.
5. Repeat steps 1 through 4 for next application.

PRePARING THe Tool

WARNING:
solvents inside the tool. This can seriously affect the life and performance of the tool.
WARNING:
engaged whenever any adjustments are made or when tool is not in use.
1. Read the Safety Instruction section of this manual.
2. Wear eye and ear protection.
3. Remove battery from tool and fully charge.
4. Ensure magazine is empty of all fasteners.
5. Check for smooth and proper operation of contact trip and pusher assemblies. Do
not use tool if either assembly is not functioning properly.
6. Keep tool pointed away from yourself and others.
7. Insert fully charged battery pack.

loAdING THe Tool

WARNING:
personal injury may result.
WARNING:
injury may result.
WARNING:
before loading or unloading nails. Serious personal
injury may result.
WARNING:
removed and the trigger lock-off is engaged
whenever any adjustments are made or when tool is
not in use.
cAuTIoN:
Keep fingers clear of pusher to
prevent injury.
1. Press pusher latch (10) and pull magazine down.
2. insert fasteners into the side of the magazine.
Enure the fastener tips are placed towards the front
of the magazine, under the nail guide (4A) in the
nail channel as shown in figure 4.
3. Push magazine closed until it locks into place.
Keep fingers AWAY from trigger when not driving fasteners to
The contact trip needs to be depressed followed by a full trigger pull
The battery should always be removed and the trigger lock-off
NeveR spray or in any other way apply oil, lubricants or cleaning
The battery should always be removed and the trigger lock-off
Keep the tool pointed away from yourself and others. Serious
Never load nails with the contact trip or trigger activated. Personal
Always remove battery pack
The battery should always be
4
4A
11