Brydge W-Touch Mode D'emploi page 2

POWER
To power on, slide power switch on back of unit from left to right and release. LED will turn green for three seconds
to indicate touchpad is on.
To power off, slide power button to left and release.
PAIR
Once touchpad is on, slide the power switch to the right (towards the LED) and hold for three seconds. LED will flash
blue until the touchpad is successfully paired.
On your device under Bluetooth settings select Brydge W-Touch.
CHARGE
To charge your Brydge W-Touch, insert the supplied USB-C cable into the charging port.
The battery is charging when the LED flashes red. The LED will turn off when the battery is fully charged.
HAVE A QUESTION? Visit www.brydge.com/support