Greenlee H4665A Manuel D'instructions page 4

IMPORTANT SAFETY INFORMATION
Do not exceed the following hydraulic power source
maximums:
• Hydraulic flow: 30 l/min (8 gpm)
• Pressure relief: 138 bar (2000 psi)
• Back pressure: 13.8 bar (200 psi)
Failure to observe this warning could result in severe
injury or death.
Do not disconnect tool, hoses, or fittings while
the power source is running or if the hydraulic fluid
is hot. Hot hydraulic fluid can cause serious burns.
Do not reverse hydraulic flow. Operation with
hydraulic flow reversed can cause tool malfunction.
Connect the pressure (supply) hose and tank (return)
hose to the proper ports.
Failure to observe this warning could result in severe
injury or death.
Do not change accessories, inspect, adjust, or
clean tool when it is connected to a power source.
Accidental startup can result in serious injury.
Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent skin
contact with hydraulic oil.
• In case of accidental skin contact with hydraulic oil,
wash the affected area immediately to remove the
oil.
Failure to observe these precautions may result in
injury.
Greenlee Tools, Inc.
H4665A Submersible Pump
• Inspect tool before use. Replace any worn or
damaged parts. A damaged or improperly
assembled tool can malfunction, injuring nearby
personnel.
• Inspect the hydraulic hoses and couplings every
operating day. Repair or replace if leakage, crack-
ing, wear, or damage is evident. Damaged hoses
or couplings can fail, resulting in injury or property
damage.
• Use this tool for manufacturer's intended use only.
Use other than that which is described in this
manual could result in injury or property damage.
• Make sure all bystanders are clear of the work
area when handling, starting, and operating the
tool. Nearby personnel can be injured by flying
debris or by flying parts in the event of a tool
malfunction.
Procedure for connecting or disconnecting hydraulic
hoses, fittings, or components:
1. Move the flow lever on the hydraulic power
source to the OFF position.
2. Stop the hydraulic power source.
3. Follow the sequence under "Hose Connections"
to prevent pressure buildup. In case some
pressure has built up, loosen hoses, fittings, or
components slowly.
Note: Keep all decals clean and legible, and replace
when necessary.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070