Operating; Loading & Transporting - Travel Buggy CRUZ Manuel D'utilisation

O PE R ATI N G
FULL BATTERY CHARGE
LOW SPEED
D IS DEPRESSED, INDICATING FORWARD DRIVE MODE
14
• While sitting comfortably in the CRUZ
scooter, press the controller button ON
to initiate power
• Next select MODE to choose speed, we
recommend beginning on the lowest
speed level
• Check that there is enough battery
power on the POWER indicator to reach
your destination
• Ensure the CRUZ is in drive mode (D)
• Rotate right hand grip slowly to
accelerate the scooter smoothly
• Engage hand brake on left side to slow
the scooters movement
LOA D I N G & T R AN S PO R T I N G
1 2
4
ENSURE FRONT WHEEL IS
SECURE AND WILL NOT
ROLL BACK
TO LOAD THE SCOOTER INTO A VEHICLE WE
RECOMMEND THE FOLLOWING STEPS:
• Power OFF your Cruz mobility scooter
• Release the grab bar beneath the
scooter (image 1)
• Pull the scooter near to the vehicle with
the front wheel facing the rear of the
vehicle
• Squeeze the hand brake and engage
the park brake to lock the rear wheels
(image 2), check that the rear wheels
are locked and parking brake is truly
engaged
WARNING: Failure to engage the park brake for the rear wheels and remove the luggage rack may cause the
scooter to roll back unintentionally when you are trying to load in the suggested manner
3
FULLY
EXTEND
5
GRAB LUGGAGE
BAR TO LEVERAGE
INTO VEHICLE
• Extend the luggage bar at the back of
the scooter to help leverage the CRUZ
into the vehicle (image 3)
• Lift the front wheel into the back of
the vehicle, check to make sure it is
secure and will not roll backwards. We
recommend placing a blanket down
over the back of the vehicle to avoid
scratches (image 4)
• Grab the luggage bar at the back of
the scooter and lift it into the vehicle
while rolling the front wheel into position
(image 5)
15