Berger Move Notice page 18

ASTRA 1
Blue Off
ASTRA 2
Green Off
ASTRA 3
Yellow Off
HOTBIRD
Purple Off
3. Press and hold (3 seconds) until LED flashes chosen satellite colour - (Ready to to scan)
Chosen
Note. This will now remain the pre-set satellite on the power inserter until this process is
repeated. Go to page 18 to start scan. The LED will flash on and off unless you have enabled
the alarm function (see page 20) in which case the LED will flash the colour and white.
1. Make sure all connections are made as shown on page 16.
2. Turn on the TV and satellite receiver if not integrated.
The Power Insterter LED will pulsate orange while powering up (this will take about 10
seconds).
Pulsing orange
When ready to scan the LED will flash blue. This colour flashing is indicating that Astra 1 is
selected if you wish to change see page 17 for details
18 18
Pattern repeats
Green Off
Yellow Off
Purple Off
Off Chosen
SATELLITE SEARCH
ENGLISH ENGLISH
Pattern repeats
Yellow Off
Purple Off
Off
Pattern repeats
Purple Off
Pattern repeats
Chosen