Scotts LPS41024S Manuel De L'opérateur page 5

INSTALLING/REPLACING THE GUIDE BAR AND CHAIN

Remove the battery pack from the pole saw

Loosen the lock knob by turning counter-clockwise.

Remove the chain cover.

Remove the bar and chain from the mounting surface.

Remove the old chain from the bar.

Lay out the new saw chain in a loop and straighten any
kinks. The cutters should face in the direction of the
chain rotation. If they face backwards, turn the loop over.
Cutter direction

Place the chain drive links into the bar groove.
NOTE: Make certain of the direction of chain.

Position the chain so there is a loop at the back of the
bar.

Hold the chain in position on the bar and place the loop
around the sprocket.

Fit the bar flush against the mounting surface so that the
bar studs are in the long slot of the bar.
NOTE: When placing the bar on the bar studs, ensure
that the adjusting pin is in the chain tension pin hole.

Replace the chain cover.
5