Beper 50.401 Mode D'emploi page 8

Handheld vacuum cleaner Use instructions
Product and accessories fig.A
1. Liquid and solid container
2. Suction vent
3. Release button
4. ON / OFF switch
5. Engine body
6. Filter
7. Charger inlet
8. Recharge indicator light
9. Battery charger
10. Crevice nozzles
11. Brush
12. Extension tube
Instructions for use
When using the appliance for the first time, let it charge for some hours so the batteries can charge complete.
Press the release button, remove the liquid and solid container and check that the suction filter is securely fa-
stened.
Insert the desired accessory into the suction vent.
Press the ON / OFF button and vacuum the material.
At the end, switch off the appliance by pressing the ON / OFF button again.
Empty the container after vacuum liquids and / or solids, or when the container is full, by pressing the release
button.
Cleaning
Switch off the appliance before cleaning it.
The outer body, the container, the suction accessories can be cleaned with a soft cloth dampened with hot water.
Do not clean with diluents, abrasive products, detergents for plastic or other; could damage the surface.
Take care not to penetrate liquids inside the slots of the appliance.
Recharge the appliance
Switch off the appliance with the ON / OFF button.
Plug the battery charger plug into a socket.
The charging LED on the battery charger light up.
Do not recharge for more than 8-10 hours.
When charging is complete, disconnect the plug from the socket.
For charging use only the supplied original adapter and do not modify the power cord or any other part of the
adapter.
Technical Data
Lithium battery pack 7,4v - 2000mah
Adaptor:
Input: 100-240v ~ 50/60hz 0,3a
Output: 9.0V - 1.0A"
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
8