TPI 474 Serie Mode D'emploi

474 SERIES
PORTABLE HEATER
When using electrical appliances, basic precautions should always be followed to reduce the risk of
fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. CAUTION: Hazard of Electric Shock. Disconnect from power supply before servicing or cleaning.
3. To disconnect heater, turn controls to off, then remove plug from outlet.
4. Connect to properly grounded outlet (or circuit) only.
5 . C A U T I O N : High temperatures. Keep cords and all other combustible material, such as furniture, pillows, bedding,
papers, clothes and curtains away from the heater. For safe and efficient operation, keep an open space around heater
of three feet in front and twelve inches at sides and rear.
6. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use the handle when moving
this heater.
7. Do not use outdoors.
8. This heater is not intended for use in bathrooms, laundry areas and similar locations. Never locate heater where it may
fall into a bathtub or other water containers.
9. A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids
are used or stored.
10. Always unplug heater when not in use.
11. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left
operational and unattended.
1 2 . D o n o t o p e r a t e any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or
damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjust-
ment, or repair.
13. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic
area and where it will not be tripped over.
14. The manufacturer recommends that an extension cord NOT be used with this heater. Avoid the use of an extension cord
as it may overheat and cause a risk of fire; however, if an extension cord is used, it must be at least the minimum wire
size and rating specified in the table listed in these instructions.
15. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed,
where openings may become blocked.
16. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or
fire, or damage the heater.
17. Use this heater only as described in this manual, Any other use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
18. This heater uses a manual reset type limit control, which opens the circuit to the heating element. The pilot light will
illuminate if the manual reset trips. If any over-temperature condition occurs, disconnect the heater, determine cause
of overheating and correct the problem. Then after heater has cooled, using a small diameter tool, push to reset through
the small hole in heater cabinet to resume operation.
IMPORTANT: OWNER SHOULD RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
OPERATING
INSTRUCTIONS
IMPORTANT
INSTRUCTIONS
FORM: 8913
ECO 1-7091