ACCO GBC MultiBind 212 Manuel D'utilisation page 4

Specifications
Type of Punch
Max. Punch Capacity per lift (80 gsm)
Max Punch Capacity Foils/PVC Covers
Max. Approx. Binding Capacity (80 gsm)
Paper Formats
Max Binding Element Cap
De-Selector Pins
Margin Depth Selector
Machine Dimensions mm (HxWxD mm)
Weight
Setting up
1
Set the machine up on a stable surface (fig. 1).
2
Test the punching system with scrap paper first before punching
your final documents.
3
Lift up both parts of the operating lever until the handle noticeably
clicks into position. Fold out the support arms on both sides of the
machine as far as they will extend.
Punching
1
Insert paper fully into the punching slot making sure they are flush
with the paper edge guide. (max 12 sheets 80gsm/2 x PVC Covers)
(fig. 2).
2
Press down on the punching handle until all pages are punched (fig.
3).
3
Lift handle to its original position and remove pages.
Comb binding
1
Place the comb, open side up, behind the metal fingers. Push the
comb to the right.
2
Press the small binding lever on the rear side of the machine slowly
to the rear, until the comb is sufficiently open (fig. 4).
3
Load the document onto the comb.
4
Move the small binding lever back to the vertical position. Remove
the bound document by pushing it to the left (fig. 5).
Guarantee
Operation of this machine is guaranteed for two years from date of
purchase, subject to normal use. Within the guarantee period, Acco
Brands Europe will at its own discretion either repair or replace the
defective machine free of charge. Defects due to misuse or use for
inappropriate purposes are not covered under the guarantee. Proof
of date of purchase will be required. Repairs or alterations made by
Register this product online at www.accoeurope.com
4
GBC MultiBind 212
Manual
12
2 Foils/PVC Covers, max 0.2mm each
145 (CombBind)
125 (WireBind 21)
A4
16 mm (ComBind)
Fixed
Fixed
112x385x160
3.5kg
Wire Binding
1
Using the edge of a desk, feed the wire through the punched
document (fig. 6).
2
Insert the document into the wire closing jaws. (wire opening face
down).
3
Support the document and pull down on the punch handle SLOWLY
until the selected size of your binder appears on the scale on the
right-hand side in the wire closing jaws (fig. 7).
4
Lift the lever back to the vertical position and remove the document.
Binding Tip
Place the last sheet /back cover of the document on top of the first
sheet, so that when the document you flip the back cover over and the
join in the wire will now be concealed between the last and second but
last sheets.
Adjusting the paper edge guide
You can adjust the paper edge guide by pressing on the guide. You can
then slide the guide along the machine to your required paper size. The
graphic representation of the punched holes on the punching channel
will be of assistance to you here.
Note: Make sure that the edges of the paper are not cut (fig. 2).
Maintenance
Please remember to empty the clippings tray regularly.
persons not authorised by Acco Brands Europe will invalidate the
guarantee. It is our aim to ensure that our products perform to the
specifications stated. This guarantee does not affect the legal rights
which consumers have under applicable national legislation governing
the sale of goods.
Location of controls
1 Paper edge guide
2 Punching handle
3 Wire closing jaws
4 Comb Holder
5 Binding Lever
6 Support Arms
7 Clippings Tray
(using GBC 21 loop wires)
G