Eurochron EQWU 882 Notice D'emploi page 2

OPERATING INSTRUCTIONS
Item no. 672871 / Version 08/12
QUARTZ WALL CLOCK EQWU 882
INTENDED USE
The product shows the time of the day on an easily readable analogue clockface.
Always observe the safety instructions and all other information included in these
operating instructions.
This product complies with the applicable national and European regulations. All
names of companies and products are the trademarks of the respective owner. All
rights reserved.
PACKAGE CONTENTS
- Quartz Wall Clock
- Operating Instructions
SAFETY INSTRUCTIONS
The warranty will be void in the event of damage caused by failure to
observe these safety instructions! We do not assume any liability for
any consequential damage!
Nor do we assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions! In such
cases, the warranty will be null and void.
- For safety and licensing (CE) reasons, unauthorised conversion and/or modifi ca-
tions of the product are not permitted. Never dismantle the product.
- The product is intended exclusively for use in dry interiors; it must not get damp
or wet.
- This product is not a toy and does not belong in the hands of children. Use the
product only out of the reach of children; the product contains parts that can be
swallowed as well as batteries.
- Condensation may form when the product is brought from a cold room into a
warm one. Therefore, wait until it has reached room temperature before using it.
- Do not leave the packaging materials unattended. They may become dangerous
playthings for children.
- Handle the product with care; it can be damaged by impacts, blows, or accidental
drops, even from a low height.
NOTES ON BATTERIES AND RECHARGEABLE BATTERIES
- Batteries/rechargeable batteries do not belong in the hands of children.
- Do not leave batteries/rechargeable batteries lying around; there is a risk that
they could be swallowed by children or pets. If swallowed, consult a doctor im-
mediately.
- Leaking or damaged batteries/rechargeable batteries in contact with the skin
can cause acid burns; therefore, use suitable protective gloves.
- Batteries/rechargeable batteries must not be short-circuited, opened or thrown
into a fi re. There is a risk of explosion!
- Normal, non-rechargeable batteries must not be charged. There is a risk of ex-
plosion! Only charge rechargeable batteries that are intended for this purpose;
use a suitable battery charger.
- Make sure that the polarity is correct when inserting the battery/rechargeable
battery (pay attention to plus/+ and minus/-).
INSERTING/REPLACING BATTERIES
Observing the correct polarity, insert one Type AA/Mignon battery into the battery
compartment on the back of the clock.
In order to ensure enduring and secure operation you should use a high-quality
alkaline battery.

A rechargeable battery may be used, but due to the lower voltage output
(rechargeable battery = 1.2V, standard battery = 1.5V) and the lower capac-
ity, the service life is much shorter, which means that rechargeable batteries
need to be frequently changed/charged.
If you still wish to use a rechargeable battery, we recommend you use a
NiMH battery with low self-discharge.
Set the time correctly, using the small red wheel above the battery compartment.
The battery needs to be replaced if major time differences suddenly occur or if the
clock hands stop moving.
If you do not intend to use the clock for a long period (e.g. if it is to be stored away),
remove the battery fi rst. If batteries grow old, they can leak and damage the clock's
battery compartment, leading to loss of warranty/guarantee!
INSTALLATION
Hang the wall clock, using the mounting bracket on the back, on a nail, screw or hook
on a vertical wall.
Due to the heaviness of the radio wall clock, ensure solid mounting! If the
clock falls, its casing will be damaged and the warranty/guarantee will be
void!
CLEANING AND MAINTENANCE
The product does not require any maintenance and should never be disassembled
for any reason.
Please use a soft, dry, clean cloth for cleaning. Do not apply too much pressure on
the casing or the front glass, as this can cause damage or scratch marks.
Do not use any chemical cleaning agents, as they can discolour the plastic casing.
DISPOSAL
a) Product
Electronic devices are recyclable waste materials and must not be disposed
of in the household waste!
Please dispose of the product, when it is no longer of use, according to the
current statutory requirements.
Remove any batteries and dispose of them separately from the product.
b) Batteries and Rechargeable Batteries
As end user, you are legally obliged (Battery Regulation) to return used batteries
and rechargeable batteries. Do not dispose of used batteries in the household waste!
Batteries/rechargeable batteries contain harmful materials and are labelled
with the symbol shown to indicate that disposal in the household waste is
forbidden. The symbols for the relevant heavy metals are: Cd=cadmium,
Hg=mercury, Pb=lead (marking can be seen on the battery/rechargeable
battery, e.g., underneath the refuse bin symbol shown on the left).
You can dispose of your used batteries/rechargeable batteries free of charge at your
community's collection point or any place where batteries/rechargeable batteries
are sold!
You thereby fulfi l your statutory obligations and contribute to the protection of the
environment.
TECHNICAL DATA
Power supply: ...................... 1 battery of type AA/Mignon
Battery life: .......................... approx. 1 year
Dimensions: ......................... 305 x 38 mm (Ø x H)
Weight: .................................. 465 g (without battery)
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by
any method, e.g. photocopy, microfi lming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. These ope-
rating instructions represent the technical status at the time of printing. Changes in technology
and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.