Projector Function - Renkforce C8416 Mode D'emploi

• Briefly push the button "TIME" (A5); the date flashes. Set it with the buttons
"+/CHANNEL" (A7) and "-/MEM" (A8) as well.
• Push the button "TIME" (A5), to adjust the time zone. Use the buttons "+/CHANNEL"
(A7) and "-/MEM" (A8) again.
• Briefly push the "TIME" (A5); the language for weekday display flashes at the low-
er right of the display. Set it with the buttons "+/CHANNEL" (A7) and "-/MEM" (A8)
("GB" = English, "DE" = German , "FR" = French, "ES" = Spanish, "IT" = Italian).
• To save all settings and to leave the setting mode, push the button "TIME" (A5).
Alternatively, you can just wait for 30 seconds without pushing any button; the projec-
tion radio alarm clock saves all input automatically and leaves the setting mode.
c) Projector function
• In battery operation without plug-in mains adapter, the projector will only be activat-
ed for a few seconds when you push the button "SNOOZE/LIGHT" (A2) briefly.
When operating the device with the enclosed plug-in mains adapter, projection will
be active permanently by default.
• To deactivate permanent projection, push the switch B7 from "ON" to the left.
• To turn the projection by 180°, push the button A1 at the top of the projection radio
alarm clock.
• Use the focus setting wheel (B12) on the rear to bring the projection into focus.
• Swivel the projector (A3) forward or back to present the projection in the desired
location.
• The projection alternates between time, indoor temperature "IN" and outdoor tem-
perature "OUT". Additionally, the current display of the barometer and the active
alarms are displayed at all times. Please note, that in the automatic mode (see Chap-
ter 9. f)) only the last temperature sensor is always shown during the projection.If you
operate another sensor, just change the channels.
53