How To Use - EBL 906 Manuel D'instructions

HOW TO USE

HOW TO USE
1. Make sure the batteries are placed correctly, make the "+/-" pole of
the batteries are corresponding to the "+/-" of the charger.
2. Start to charge when put the batteries into charger: the LCD display
will be bright about 0.5 seconds for self-inspection, then turn off and
standby for charging. (If the LCD keep flashing means the battery is
non-rechargeable, not compatible or defective, please stop to charge
at once.
3. Charging AA/AAA/C/D Ni-MH Ni-CD rechargeable batteries: One
LCD corresponding to one slot, when the LCD indicator shows
" " means the batteries have been fully charged. And the charger
is individual, could charger different type and capacity compatible
batteries in the same time.
4. Charging 9V Ni-MH Ni-CD rechargeable batteries: the LED will
always keep lighting. Should to calculating its charging time for 9V
battery(for reference only): 150-300mA about 6 hours.
5. Discharge: Press the button to change mode, LCD screen will
display "DISCHG" while charging. Please note that the charger will
automatically turn to charging mode "CHG" after the battery is
discharged.
6. "ERROR": If the battery is broken (0 Volt) and install battery
incorrectly, the charger will shows "ERROR" to remind you personally.
04