CAMP SPEED COMP Mode D'emploi page 15

The helmet marked EN 12492 (see Tab.A) is intended to be used for the protection of the head against
the risk of falling objects during the practice of mountaineering, climbing and other vertical sports that
use similar techniques.
The helmet marked EN 1077 / B (see Tab.A) is intended to be used for the protection of the head against
the risk of impacts following falls of the user during the practice of alpine skiing and snowboarding.
Use
Choice of the helmet: the helmet should be adapted to the intended use, as shown in chart A.
Adjustment:
follow:
1) Headband adjustment [2]:
• Adjust the headband at its maximum extension.
• Put the helmet on the head.
• Tighten the headband according your head size, by the headband adjustment as shown in
2) Chin straps [3] adjustment and closing (
3) Speed Comp: paddings are integral parts of the helmet; in order to guarantee an adequate protection, the hel-
met must not be used without paddings or in case they are damaged. Spare front padding supplied together
with the helmet can be replaced by the user depending on the dimensions of his/her head (
in the original position.
REVISION
normal inspection required before, during and after each use, this product must be inspected by a skilled person
recorded on the product's life sheet: keep this literature for inspection and reference for the life of the device.
Check the legibility of the product's markings.
In case of one of the following defects are present, the product should be withdrawn from service immediately:
• local deformation of the shell [1]
• cracks on the outer or inner surface of the shell [1]
• defective riveting
In case of one of the following defects, the defective part should be changed (tab.B):
• incorrect functioning of the closing system [4]
• incorrect functioning of the headband adjustment system [2]
• absence or bad condition of padding [6]
• cut, tears and abrasions of stitching or straps.
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service
immediately. Each product in the safety system can be damaged during a fall and must be always inspected before
use it again. Do not continue to use a product after a major fall because a damage may have occurred, even no
external signs are visible.
LIFETIME
in any case cannot exceed the end of the twelfth year from manufacturing (i.e. manufacture year 2021, lifetime
in the absence of causes which would place the product out of order with the condition that periodic inspections
recorded on the life sheet of the product.
).
13
O
.
).
[5] ( ).