Publicité
Les langues disponibles
Les langues disponibles
"CLICK N GO 2" PLOW ATTACHMENT
P P olaris – Ranger XP 800
Plow Attachment Installation Procedure
1) Assemble the two (2) rear spacers
attachment plate
with two (2) M8-1.25 x 25 mm
01
carriage bolts
and two (2) M8-1.25 hex. nuts
D
Tighten the first threads only.
D
02
E
2) Remove the bolt at the center of the vehicle holding
the skid plate. See the image below.
3) Assemble the front of the attachment plate
the frame of the vehicle by placing the
M6-1.0 x 30 mm hex. bolt
removed in the previous step.
4) Center the attachment plate
frame using a ruler.
5) Drill in six (6) holes in the skid plate of the vehicle
with the drill bit
provided in the kit while using
G
the attachment plate
Front of
the vehicle
.
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810514
A A -2810514 rev. A
Printed in Canada
ASSEMBLY INSTRUCTIONS
to the
02
01
Front of
the vehicle
on
01
in the hole of the bolt
03
with the vehicle
01
as a reference.
01
6) Insert the four (4) square bend U bolts
between the frame and floor of the vehicle, pass
through the holes drilled in the previous step, and
secure with eight (8) M8-1.25 hex. nuts
.
E
bolt must connect the frame and the skid plate of
the vehicle, the spacer
plate
01
be installed to the front, and the 105.6 mm square
bend U-bolts
plate
01
02
01
7) Tighten all bolts and nuts assembled so far with an
appropriate tool.
Assembly of the V-Plate to the Attachment
Plate
8) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and four (4) M8-1.25 hex. nuts
the holes corresponding to the width of the four (4)
slotted holes of the attachment plate
first threads only in order to leave a space between
the head of carriage bolts
KIMPEX NO.
and the attachment
02
. The 92.9 mm square bend U-bolts
to the rear of the attachment
C
.
B
C
on the V-plate
E
and the V-plate
D
374457
and
B
C
. Each U-
E
must
B
Front of
the vehicle
D
in
A
. Screw the
01
.
A
2
Publicité
