Power Dynamics PDA-C808A Manuel D'instructions page 2

ENGLISH
A. FRONT PANEL SECTION FEATURES
1. BALANCED Mic INPUT
Electronic Balanced inputs acceptable a standard XLR male connector. It is designed to accept a
balanced low impedance input signal, Phantom power (15 volts) for condenser microphones is
always on and available. It has an input impedance of 1K ohm. The connector is wired as: Pin= shield;
Pin3= negative (cold).
2. BALANCE INPUT(LINE)
Electronic Balanced inputs accepts a standard ¼" jacks connector. It is designed to accept a balanced
high impedance input signal.
3. VOLUME
This is function to adjust the volume of a signal connection into each channel and adjust the volume
of output, together with the master fader.
4. TREBLE
This control gives you up to 15 db of boost or cut at 10 kHz and above, and it is also flat at the detent.
Use it to add sizzle to cymbals, and an overall sense of transparency or edge to key‐boards, vocals,
guitar, and bacon frying. Turn it down a little to reduce sibilance, or to hide tape hiss.
5. LOW
This control gives you up to 15 dB boost or cut at 100Hz and below. This circuit is flat (no boost or
cut) at the center detent position. This frequency represents the punch in bass drums, bass guitar, fat
synth patches, and some really serious male singers.
6. EFF
This is a send control to the reverb bus. It controls the amount of reverberation added to the input
signals.