Samsung NX6087S Serie Mode D'emploi page 43

To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
1. Make sure the oven door is closed completely and unlocked.
2. Tap , and select Self Clean using the dial knob. Then, select the cleaning time
by turning the dial knob one or more times in accordance with the table below.
Left turn
2-hour cycle
3. Tap START. The oven door is locked and the oven begins to heat up.
4. When the self-cleaning cycle is complete, the oven beeps. The door will remain
locked until the oven temperature falls below 400 °F (200 °C). You can open the
door when it is safe to open.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
NX60T8711SS_AA_DG68-01220A-00_EN.indd 43
Default Right turn
3-hour cycle 5-hour cycle
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 on the previous page.
2. Select Set Delay Start.
3. Set the time you want the oven to start self-cleaning using the dial knob.
4. Tap START. The oven will start self-cleaning at your specified time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, tap OFF. The cycle turns off, but the door
remains locked and the Lock icon blinks until the oven temperature falls below 400 °F
(200 °C).
NOTE
English 43
3/26/2020 9:01:04 PM