Sharing Music Via Bluetooth (A2Dp Sharing); Satellite Navigator For Motorcycles; N-Com Intercom; N-Com "900" / "600" Series Intercom Pairing Up - Nolan N-Com X Serie Sécurité Et Mode D'emploi

12.1 Sharing music via Bluetooth (A2DP Sharing)

During the intercom connection, you can start playing music by briefly pressing the "" key for about 2
seconds. The music will be played in both systems.
Music sharing temporarily cuts off the intercom conversation; however, this can be automatically restored by
stopping the music (this is done by pressing the "" key for about 2 seconds).
N.B.: Music shared through the intercom can be managed by both systems, for example, both systems can
change the track by pressing the relative command.
N.B.: the "Music Sharing" function can be used with the N-Com series "900" / "600".
13

SATELLITE NAVIGATOR FOR MOTORCYCLES

B601 system is compatible with the most common satellite navigators for motorcycles. For a list of compatible
models and additional details, visit the website www.n-com.it
To pair up a satellite navigator to the B601 system, follow the procedure illustrated in Chapter 10.
N.B.: Intercom connection is automatically cut off every time the navigator gives directions and restored at the
end of the message from the navigator.
14

N-COM INTERCOM

The N-Com B601 system allows communication with other N-Com systems, up to a maximum distance of
about 150 m (in open field, with no obstacles). The range of the communication varies depending on the N-
Com systems used.
Important: The procedure described below refers exclusively to the pairing up and operation between the
B601 and the "900" / "600" series N-Com systems.
To pair up to N-Com systems of a range other than the "900" / "600" series, please refer to the procedure
described in chapter 15 "Universal Intercom".
N.B.: The range and quality of the communication may vary significantly depending on the presence of
obstacles, weather conditions, magnetic fields.

14.1 N-Com "900" / "600" Series Intercom pairing up

• Make sure the systems are turned off.
• Put the systems in "Configuration" mode: press the "n" key and keep it pressed for 4 seconds, until you hear
the voice announcement "
• On both systems, press the "" key until you reach the option "
• On system A, press the key pertaining to the "pre-setting position" where you wish to save system B.
Pairing up CHANNEL 1
Pairing up CHANNEL 2
Pairing up CHANNEL 3
The Intercom connection with the selected channel is automatically activated at the end of the pair up
procedure.

14.2 N-Com "900" / "600" Series Intercom function (one-to-one connection)

To establish an Intercom connection with one of the systems stored in memory, simply press the command
related to the channel where the system was saved.
Configuration Menu ".
Briefly press "n".
Press the "n" key twice.
Press the "n" key three times.
Intercom pairing ".
19