Albrecht BPA 500 Guide D'utilisation page 11

2. Charging
Before the fi rst use, please recharge the device fully until the red
light of the function button turns off.
Low power notifi cation
When the power becomes lower than 10%, the function button
will fl ash red and a voice message will announce power lower
than 10%. Please recharge immediately.
3. Turn On/Off
Turn on: long press function button for 3 seconds until the voice
announcement „Power On" and the function button starts fl ash-
ing blue.
Turn off: When the device is on, long press function button for
3 seconds until the voice announcement „Power Off" and light
stops fl ashing.
4. Bluetooth Pairing/Connection
1. When the device is off, long press function for 5 seconds until
red and blue light fl ashes and the voice announcement „Pairing".
2. Switch on Bluetooth at your cellphone, search for „Albrecht
BPA 500" and press connect. When the red and blue light chang-
es to blue, a „Beep" sound is heard and pairing is complete.
3. The BPA 500 will connect automatically to the last paired unit
if you turn it on the next time.
4.1. Second connection with GPS/cellphone
In the fi rst step pair and connect the fi rst Bluetooth device, then
turn off the BPA 500. Now pair and connect the second Bluetooth
device in the same way and turn off BPA 500 again.
If you now start the BPA 500 again, it will automatically con-
nect to both Bluetooth devices (you hear 2 Beep tones).
11